Titanium Alloy Grade4 is “unalloyed” titanium offering optimum ductility and cold formability. The material has high impact toughness and is readily weldable. The material is capable of deep drawing.
Standard Specification: ASTM B348, ASME SB348, ASTM F67 Surgical Implant , ISO, DINAMS-T-9046B CP1,AMS-T-9047A CP70,AMS 4901,AMS 4921 MIL-T-9046J CP1,MIL-T-9047G CP70
Standard |
Werkstoff No. |
UNS |
Commercial Pure Titanium Grade4 |
3.7065 |
R50700 |
Technical Data Sheet
Chemical Composition |
||||||
Weight % |
Ti |
C |
Fe |
N |
O |
H |
Commercial Pure Titanium Grade4 |
Balance |
0.08 |
0.5 |
0.05 |
0.4 |
0.015 |
Typical Mechanical Properties (Tensile Requirements)
Material |
Tensile Strength, min |
Yield Strength (0.2% Offset) min or range |
Elongation in 4D,min% |
Reduction of Area Min % |
||
ksi |
MPa |
ksi |
MPa |
|||
Commercial Pure Titanium Grade4 |
80 |
550 |
70 |
483 |
15 |
25 |
1. TitaniumRodfor Neurosurgery Implants KirschnerRod Specification (mm) Φ7mm~Φ230mm Length (mm) 1000~3000
Titanium 6-6-2 (6Al-6V-2Sn) is a heat treatable, high strength titanium alloy with higher strength and section hardenability that 6Al-4V. but with lower toughness and ductility and limited weldabilit
Titanium Ti5Al2.5Sn (Grade 6) is a high strength alloy which is most commonly used in airframe and jet engine applications. Titanium Ti5Al2.5Sn (Grade 6) has good weldability, stability and strength
Standard Specification: ASTM B348, ASME SB348, ISO, DINAWS A5.16 (ERTi-36); Standard Werkstoff No. UNS Titanium Al